-
1978 Honda CB (1978)
Last year for the single overhead cam series(SOHC) .....all totally unmolested, unrestored and original.....the black F series had more performance than previous models with larger valve set at improved angle and a racier cam for better breathing.............5 speed trans and triple disc brakes. this bike was traded in at a Honda dealer in Saskatchewan Canada in the mid 80's and it sat on a display shelf untill the early nineties when I purchased it and since then has sat in heated storage.Before it went on display the gas tank and carbs were drained and some oil poured into each cylinder.A couple of times a year the engine was kicked over several times to keep an oil film on the cylinder walls but it has not been started .You would be responsible to get it up and running if that was your desire. This CB750F was actually built in the 4th month of 1978 so is one of the last ones of the SOHC series as I believe the next month or two,early production of the Twin Cam or DOHC 1979 model series started.(totally different engine) It has the original owners manual and tool kit under the seat.2016-07-27 04:44:34Moose Jaw, Saskatchewan, Canada61910,670.00 -
1971 Honda CB (1971)
This is for a 1971 k1 cb750 four with the correct 1971 engine both begining w/ serial,107**** build date 2/71...This bike was bought from the original owner after sitting since 1976. it has less then 50 miles since a complete resto. Bike features most of it original parts including chrome, none of which has been replated.2016-06-19 04:41:59Saskatoon, Saskatchewan, Canada124400 -
1983 Honda CB1100F Canadian Model (1983)
Fuel tank,sidecovers,guages and rear tail piece replaced back over 10 years ago while you could still buy them new from Honda Canada.They are now obsolete and no longer available.Older pieces were kept by the previous owner and resold...they were faded somewhat but were not replaced due to any damage.The previous owner had 3 of these which 2 were traded off to us.This one was the least used with approx 22,000 kilometers.The bike had sat for years in a shop and when we went to first start the bike again a ring snagged and broke so we removed the cylinder block, honed the bores and installed new factory rings along with the new gaskets and seals as required.We also adjusted the valve clearances and cleaned the carbs.The oil & filter was changed using fresh Honda GN4 10-40 .It was recently test ridden and runs flawlessly.The back tire is near new while the front has some wear.We have the original airbox which had some mods done to it to increase air-flow.We also have the stock signal lights.The seat is a Corbin gunfighter.The carbs have a dyno jet kit installed along with the seperate K&N air filter pods.We do not have the stock seat or exhaust system. Any shipping or transportation costs will be up to the purchaser2013-08-31 01:05:23Moose Jaw, Saskatchewan, CA13,6727,500.00
Honda CB Price Analytics
Moto blog
Honda has applied for a European Vehicle Type Approval for a new model
Fri, 06 Aug 2021Earlier this year, a Japanese company patented the name and layout of the new NT1100 model. A while later, renderings of what a sports touring car with the engine and transmission from the CRF1100 Africa Twin might look like appeared on the network. Since then, no new information about the appearance of the NT1100 has been leaked, but just the other day it became clear that the model will be presented soon.
Honda has unveiled the 2022 CRF450RX
Fri, 04 Jun 2021There are no crutial changes, the manufacture's engineers, with the help of factory racers, were fine-tuning the motorcycle. As a result, the enduro CRF450RX, like the cross-country CRF450R, received a retuned electronic engine control unit, as well as recalibrated shock absorbers, which had a positive effect on enduro handling.
Honda has announced plans to go completely zero-emission
Sun, 30 May 2021The company President Toshihiro Mibe said that Honda is committed to being completely carbon-neutral across all of its products. To do this, the company is expanding the range of electric vehicles and has also developed a standard for replaceable batteries Honda Mobile Power Pack.
Looking forward to the NX200 - Honda's new touring enduro
Thu, 06 May 2021It will be a real adventurer, only a small one. The motorcycle will focus on the Asian markets. These isn't much information about the bike yet, but it is preliminary known that it will be built on the CB190 platform and will receive a single-cylinder engine with a displacement of 184 cc.
The other day, Honda patented the name and layout of the NT1100 motorcycle
Fri, 12 Feb 2021The Africa Twin parallel twin will be installed in another chassis - an asphalt tourist one. Unfortunately, at the moment there are no official pictures, only the fantasies of fans and third-party designers. Only one thing is clear - the engine will be 1100cc, and just like the CRF1100 Africa Twin touring enduro and CMX1100 Rebel chopper, the engine will be offered with both a conventional motorcycle foot-shift gearbox and a DCT robot.
Honda has updated its flagship GL1800 Gold Wing tourer for 2021
Tue, 19 Jan 2021There are no radical changes, improvements have affected parts of Honda tourers that are important for ensuring the comfort of the rider. In addition, new color and graphic schemes have appeared for the 2021 models. The Tour version has Gunmeatal Black Metallic and Candy Ardent Red.
Honda introduced the European version of the MSX125 Grom 2021 model year
Sat, 12 Sep 2020The legendary microbike received an engine that complies with Euro5 standards and significantly upgraded looks. In addition, the MSX125 will now also be sold under its own name Grom on the European market. Honda Grom received an updated 125cc single-cylinder engine with 9.6 horsepower, aggregated with a five-speed gearbox instead of the previous "four-speed".
Honda will introduce the new CBR600RR later this year
Wed, 08 Jul 2020There has been no official information from Honda about the new generation CBR600RR yet, but it became known that the 2021 model will echo the older Fireblade in terms of its exterior. The "Six hundred" will receive a "two-eyed" LED head optics, the air intake will be located in the middle. Winglets will be added to the fairing to increase downforce at high speeds.
Honda has patented a technical solution from the arsenal of the Gold Wing tourer.
Thu, 02 Apr 2020The modern Honda Gold Wing is equipped with a double wishbone front suspension, which not only increases ride comfort, but also allows the geometry of the motorcycle not to change during acceleration and braking. Lever suspension, which stabilizes the bahavior, may appear on other models of the company in the future. This is hinted at by patent images of similar systems integrated into the design of completely different motorcycles - the “classic” CB1100 and the small-capacity C125 Super Cub.
Little brother: Honda introduced a "nano version" of the X-ADV scooter
Sun, 11 Aug 2019The model is called ADV 150 and, despite its similarity with the X, it has nothing to do with it. The engine is a single-cylinder with a volume of 149.3 "cubes", developing 14.2 hp at 8500 rpm and 13.8 Nm at 6500 rpm. Suspension is a regular telescopic fork and two Showa rear shocks.